Page 1 of 1

EW7047 USB 2.0 hard disk enclosure 3.5" SATA & IDE

PostPosted: 15 Apr 2018, 16:18
by TomV
Hello,

I purchased one of these at MediaMarkt in order to connect my IDE drive to my new computer which does not have any IDE connections. I plugged the miniature IDE cable to the drive, then realized it should probably have gone the opposite way in order to fit better within the case. However it fits extremely snugly, and in trying to take it off the drive, the cable and black plastic connector housing comes apart. In order to actually remove it, I fear it is going to completely tear up the connector (if not the cable) as I will have to use pliers to pull it off it seems.

I wondered how to get another of the miniature cables - I have a lot of IDE cables but they are too long to fit inside the housing for the drive.

Is this the proper form to use?
http://www.ewent-online.com/spareparts? ... derland_nl

Thanks,
Tom

Re: EW7047 USB 2.0 hard disk enclosure 3.5" SATA & IDE

PostPosted: 16 Apr 2018, 10:32
by Joyce
Hello Tom,

Yes, please use that form.
Then we will make sure you receive miniature IDE cable for EW7047.

In case you are Dutch: Je mag de aanvraag ook in het Nederlands indienen ;)